Shure MXWANI8 8-Channel Audio Network Interface

Used – Good: The item was removed from a working system and is in good condition. It has slight markings and minor cosmetic damage. It will arrive repackaged. It may be missing parts, accessories, or instructions.

The Shure Audio network interface streamlines Microflex Wireless connectivity to conference room AV systems over 8 channels to enable easy set-up. Features include corporate uplink mode and Dante networking to transport low-latency digital audio.

FEATURES

• Analog connections: 4 or 8 block connector channel outputs, with 1 or 2 block connector inputs (model dependent)
• Four port gigabit switch: Optimized port configurations for connection to the Access Point Transceiver and Networked Charging Stations, third party control systems, and corporate networks 
• Ethernet connectivity: Send audio and control signals over long cable runs of up to 300 feet or anywhere over a corporate network
• Power over Ethernet: Port 1 of the rear panel switch supplies power over Ethernet to the Access Point Transceiver for simplified installation
• Corporate uplink mode: Link to the corporate network for remote control of system settings while keeping audio off the network for security and to reduce bandwidth
• Front panel controls: Mute or solo channels and set input/output levels easily from the front panel
• PC/Mac software control: Access the Microflex Wireless Control Software from a networked computer for input/output levels and port configuration 
• Dante™ networking: Transports low latency digital audio received from wireless microphones over Ethernet to any other Dante-equipped device
• Headphone output: Solo audio signal on any channel

SPECIFICATIONS

• Audio Frequency Response: 20 Hz to 20 kHz (+1, −1.5 dB)
• Dynamic Range: 20 Hz to 20 kHz, A-weighted, typical
  • Analog-to-Dante 113 dB
  • Dante-to-Analog 110 dB
• Output Noise: 20 Hz to 20 kHz, A-Weighted, typical
  • Line: −84.5 dBV
  • Aux: −95.2 dBV
  • Mic: −106.5 dBV
• THD+N: 20 Hz to 20 kHz+4dBu analog input, −10 dBFS digital input, <0.05%
• Polarity: Non-inverting, any input to any output
• Dimensions H x W x D: 1.7 x 19.0 x 14.4 in. (44 x 483 x 366 mm)
• Weight: 7.1 lbs (3.2 kg)
• Housing: Steel; Extruded aluminum
• Power Requirements: 100 to 240 V AC, 50-60 Hz, 1 A
• Operating Temperature Range: −18°C (0°F) to 63°C (145°F)
• Storage Temperature Range: −29°C (-20°F) to 74°C (165°F)

ANALOG CONNECTIONS

• Outputs
  • Configuration: Active Balanced
  • Impedance: 310 Ω
  • Clipping Level (minimum): Line +26.2 dBV, Aux +16.2 dBV, Mic−3.8 dBV
• Input(s)
  • Configuration: Active Balanced
  • Impedance: 10.6 kΩ
  • Clipping Level (minimum): Line +23.8 dBV, Aux +10.8 dBV
• Headphone Output:
  • 6.35 mm (1/4") TRS, 100 mW, 350 Ω, dual mono (will drive stereo phones)
  • 0 dBV = 1 V RMS; 0 dBu = 0.775 V RMS; 0 dBV = 2.2 dBu

DIGITAL SIGNAL PROCESSING

• AD/DA Converter: 24-bit, 48 kHz
• Latency: Estimated Nominal, ±0.1 ms
  • Analog-to-Dante 0.21 ms
  • Dante-to-Analog 0.24 ms + TN
  • TN = Network latency in milliseconds, as set in Dante Controller.
  • Note: Dante network latency is typically associated with the receiving device.

NETWORKING

• Network Interface: Four-Port Gigabit Ethernet Switch, Dante digital audio
• Uplink Port (Port 4): Selectable, blocks multicast traffic
• Power over Ethernet (PoE): Provided on Port 1 to power MXWAPT
• Cable Requirements: Cat 5e or higher, shielded, 100 m maximum between network devices
• Network Addressing Capability: DHCP, link-local, static
• Transmitter Output Power: Bands: Z10, Z11, Z14, Z15