Doug Fleenor Design

The DMX Decelerator II is a DMX512 isolator and re-timing device. It can receive any signal within the DMX512 specification and it can accept some signals outside of the specification. It produces a...

The Doug Fleenor Design DMX1REL20A is a single channel unit, designed to switch up to a 20 amp line voltage load, and uses a 30 amp relay. The unit is provided with two 18" 12/3 SJ pigtails for...

The DMX8DIM is an eight output 'green' dimmer designed for minimal losses, low idle power (less than 1Watt), and low maintenance (no fans or air filters). It is designed to operate: High efficacy...

The Doug Fleenor Design Entry Station Two is a stand-alone DMX snapshot recorder which can store two preset scenes or "looks". It can be used as a stand-alone main station or configured as a remote...

Doug Fleenor Design Preset 10 Architectural DMX512 Playback DeviceProduct DescriptionThe Preset 10 Architectural is a DMX512 playback device that can take up to ten snapshots from a DMX console and...

The Preset 10 Portable [PRE10P] can act as a backup for any DMX512 lighting console or as a stand-alone DMX512 preset console. The PRE10P is a DMX512 playback device that can take up to ten snapshots...

Doug Fleenor Design standard products and most custom products have rack kits available for mounting units in 19" racks. The RK16-1 is one set of 1" wide x 6" deep gray chassis for 1U models. The...

Doug Fleenor One Universe A/B Switch selector switch was specifically designed to switch DMX512 signals. Originally designed to switch between primary and backup consoles, this switch is often used...

The Preset 10 Ethernet Architectural is a four universe playback device that can record ten snapshots of sACN data. These presets can be recalled with a press of a button. FEATURES  Multiple...